Creative Steel Inc.
Back to Support

Installation Guide

Mopar ELIMIVIBE® Engine Mounts

Charger, Challenger, 300, Durango, Grand Cherokee

Engine MountsModerate
Download Original PDF (503) 316-1811

If your vehicle has engine mount adapters (see the PDF for a reference photo), you'll transfer them onto your new ELIMIVIBE® mounts. Otherwise you'll use the supplied line-up pins. Keep all hardware finger-tight until the mounts are aligned in the vehicle.

Vehicles With OEM Adapters

  1. Transfer the engine mount adapters from the OEM mounts to the new ELIMIVIBE® mounts. Leave the adapter nut loose for now.
  2. Place the mounts in the vehicle and start all hardware finger-tight.
  3. Torque the top nut on each mount to 59 ft-lbs.
  4. Torque the two adapter-to-bracket bolts to 59 ft-lbs.
  5. Lower the engine until it rests fully on the mounts, then torque the two supplied subframe bolts to 35 ft-lbs.

If your vehicle uses these adapters, do NOT use the supplied line-up pins.

Vehicles Without Adapters

  1. Install the supplied line-up pins into the top of each engine mount using a small screwdriver.
  2. Place the mounts in the vehicle and torque the top nut to 59 ft-lbs.
  3. Torque the two supplied subframe bolts to 35 ft-lbs.

Torque Specs

Top mount nut59 ft-lbs
Adapter-to-bracket bolts (if equipped)59 ft-lbs
Subframe bolts35 ft-lbs

Questions? Call Creative Steel at (503) 316-1811, M–F 8:30am–4:00pm PST, or email inquiries@creative-steel.com.

The original PDF includes diagrams and reference photos. Download for the complete visual guide.

Download PDF